Northstar-trailers SPORTSTAR III Manual do Utilizador

NORTHSTAR TRAILERS Assembly Guide for SPORTSTAR III Trailer Congratulations! You are the proud owner of a NORTHSTAR trailer. Please

Tip: Once the lights are installed, pull any excess wire back into the frame. STEP 6: ATTACH FENDERS a. Align the fender bolt-holes with th

a. Remove the plastic caps from the rear corners of the trailer frame. b. Attach the rear corner brackets (12) to the frame using 1” bolts (L), sma

cotter-pins are installed in side-rail pins. Make sure that at least one leg of cotter-pin is bent to 90 degrees. Note: the front brackets run parall

Note: The dealer that sold you this trailer will ship you the trailer’s Certificate of Origin. The certificate will arrive approximately two weeks aft

TRAILER PARTS LIST HARDWARE Part No. Part Description Qty. 1 Frame (deck) 1 2 Tongue (wit

IMAGES OF PARTS AND HARDWARE **On some trailers the spare tire mount is found on the top of the tongue.** INVERTED ASSEMBLY [

This trailer requires inverted assembly. (Assembled upside-down). Start by turning the trailer frame upside-down so the trailer deck is facing the gro

STEP 2: ATTACH WHEELS TO AXLE Note: the hub assembly comes attached to the wheels with washers and pre-lubricated bearings. Upon removing the dust-c

Note: the dust-cap has an exterior Zirk fitting access, and does not need to be removed to grease the bearing. Grease the wheel bearings a minimum of

cotter-pins are installed, and that at least one leg of each cotter-pin is bent to 90 degrees. STEP 4: FINAL WIRING ADJUSTMENT a. Ensure

ROTATE THE TRAILER TO AN UPRIGHT POSITION. Position the trailer so the tires are on the ground. More than one person is required to rotate the tr

a. Fasten the taillight/brake light L-brackets (Q) to the frame using two, 3” bolts (X), one small flat-washer (K) and one small locknut (V) for eac